Cutting 3mm plywood - Common Problems - LightBurn Software Forum

LE-4040 20w. I have the laser focused at 30mm. I am trying to cut out a very intricate design and am having some problems. On the very small parts it is burning more area than I would like. I am wondering recommended settings. Is it better to run lower power and more passes? Is 3mm too thick for my laser? What mm/m should I be running? Newbie here so any advice is appreciated.

How to cut 10mm? - LightBurn Software Questions - LightBurn Software Forum

Cutting settings for 9mm wood - LightBurn Software Questions - LightBurn Software Forum

Have a problem with cut - LightBurn Software Questions - LightBurn Software Forum

Cutting from both sides allignment issue - Atomstack - LightBurn Software Forum

Trouble cutting 3mm ply - Tips and Tricks - LightBurn Software Forum

Laser problem with cutting straight - Community Laser Talk - LightBurn Software Forum

Cut through plywood is inconsistent - Ruida controllers - LightBurn Software Forum

Cutting plywood - LightBurn Software Questions - LightBurn Software Forum

Cutting thru with plywood - Uncategorized-to-sort - LightBurn Software Forum

Cut through plywood is inconsistent - Ruida controllers - LightBurn Software Forum