Fibre Glast - PVA Release Film

PVA, or polyvinyl alcohol, should be used with our #1016 Partall Wax for the easy release of parts from a mold. Wax should be applied to the mold, 3–4 layers thick, and buffed to a high gloss. Once the final layer of wax has dried, PVA should be applied with the following considerations:PVA can be brushed on, but for best results, apply with a spray gun, 12–18 inches away from substrate. Generally, apply in three layers: the first, a thin mist, allowing 10-15 minutes to dry completely.

Urethane Casting Resin Shore A in stock

Experienced fabricators will likely run across that hard-to-separate part, whether it's larger in nature or just stubborn—which presents a challenge for demolding. Standard wedges only reach a few inches into any mold, and using force can result in damage. Applied air pressure provides a solution.Our #958 Air Injected Wedge is designed to deliver air all the way to the sticking point to provide pressure where it is needed most.

Air Injected Wedge

Fibre Glast FibRelease

These two compounds work together, and pack a one-two-punch for polish after parts have been sanded. Not only do they produce an impressive shine, but

Step 1 and 2 Mold Polish

Low Temperature Release Film for vacuum bagging in stock - Fibre Glast

PVA Water Based Mould Release - Polyvinyl Alcohol

Composite Mold Construction Guide

👍 EFFORTLESS MOLD RELEASE - Having a tough time taking projects out of its mold? This PVA release agent forms a barrier between the parts and mold

PVA Water Based Mould Release - Polyvinyl Alcohol Agent for Epoxy, Polyester, Vinyl Ester, Resin, Gel Coat, Polyurethane Foam, Silicone-Spray or

Fibre Glast Kevlar & Carbon Kit pequeño – Kit de

These two compounds work together, and pack a one-two-punch for polish after parts have been sanded. Not only do they produce an impressive shine, but both are formulated so that fabricators use only about half the amount of compound compared to traditional materials. They naturally cool the surface as it's polished, preventing burn-through. Step One picks up where sanding leaves off and removes scratches left behind by 600- to 1000-grit sandpaper.

Step 1 and 2 Mold Polish - Step 1 (1 lb can)

Tech Tip

Durable Acid Brushes are inexpensive and ideal for applying surface coat or casting resins into the most detailed, complex molds. The tough, horsehair

Acid Brush

Available perforated and non-perforated, our Low Temperature Release Film makes for an easy release of vacuum bagging materials from your part once

Low Temperature Release Film

Preval Sprayer in stock for same day shipping - Fibre Glast