Inverted Build/work Area on Atomstack A5 pro - Getting Started With LightBurn - LightBurn Software Forum

Hello folks. I am new to laser engraving and recently purchased an Atomstack A5 pro. After some trial and error I was able to get it recognized on my Macbook pro (Big Sur). Before I turn on the atomstack I move the laser to the ‘home’ position in the bottom left corner. (Is this incorrect location for the atomstack ‘home’ position?) I start LIghtburn. On the ‘move’ tab I select ‘Set Origin’ and ‘Set Finish Position’, because this is the origin of the print and where I want it to return when

Picture Engraving AtomStack A5 Pro+ - LightBurn Software Questions - LightBurn Software Forum

Atomstack A5 Pro laser moves but won't fire - LightBurn Software Questions - LightBurn Software Forum

Software for Mac? : r/Laserengraving

AtomStack A5 not burning - GRBL - LightBurn Software Forum

Settings Atomstack A5 Pro doesn't work - LightBurn Software Questions - LightBurn Software Forum

Reversed Movement - LightBurn Software Questions - LightBurn Software Forum

Questions regarding Lightburn and Engraver - Getting Started With LightBurn - LightBurn Software Forum

AtomStack is communicating with Lightburn but wont run the cut - LightBurn Software Questions - LightBurn Software Forum

Atomstack A5 Pro laser moves but won't fire - LightBurn Software Questions - LightBurn Software Forum

Inverted Build/work Area on Atomstack A5 pro - Getting Started With LightBurn - LightBurn Software Forum