Masking tape holder - Free Laser Designs - Glowforge Owners Forum

I got tired of putting one arm through the center of the roll in order to pull the tape smoothly and I didn’t want to pay $50 to buy a holder that was way too wide for a roll of 12" tape. So I made one based on the metal one on USCutter.com. They have a video which shows how to load the roll onto the holder. The end of the tape goes under the front roller, sticky side down. I cut three sets of the sides on my GF and glued them together for strength. I cut a 13" wide base from a scrap piece

How to mask non proof grade wood or materials - Glowforge Tips and Tricks - Glowforge Owners Forum

Using Masking Tape? - Beyond the Manual - Glowforge Owners Forum

Best possible results? - Community Support - Glowforge Owners Forum

Phone Holder / Phone Stand - Free Laser Designs - Glowforge Owners Forum

DIY Projects With My Glowforge - Shanty 2 Chic

Transfer Tape Dispenser - Free Laser Designs - Glowforge Owners Forum

Best possible results? - Community Support - Glowforge Owners Forum

Is this Safe to use? - Beyond the Manual - Glowforge Owners Forum

Masking tape holder - Free Laser Designs - Glowforge Owners Forum

Material Fasteners (Hold Downs) - Sick of Using Duct-tape - Made on a Glowforge - Glowforge Owners Forum