Sandbox Electronics I2C Passive Extender/ Patch Board - Sensors & probes – Sensors & Probes

This I2C extender has eight 4-pin interlock connectors on board. The pinout of the connector is the same as on Arduino Sensor Shield, which is, from top to bottom, GND, VCC, SDA, and SCL. All pins with the same function are connected in parallel.

10,000ppm MH-Z16 NDIR CO2 Sensor with I2C/UART 5V/3.3V Interface for Arduino/Raspeberry Pi

Open Source Thermal Imager with TFT Display

Sandbox Electronics

Sandbox Electronics I2C Passive Extender/ Patch Board - Sensors & probes – Sensors & Probes

Sensors and breakoutboard for Raspberry Pi

Sandbox Electronics, We research, We design, We build, We share…

I2C Extender from LEK Electronics on Tindie

Communica South Africa

SparkFun expLoRaBLE Hookup Guide

The linear resistance to voltage module was designed for the eTape liquid level sensors. The eTape sensor plugs directly into the four-pin header on

0-5V DC Resistance to Voltage Module | Milone Technologies | Sensors & probes | Voltage | Resistance | DC | Module

1.On board 3-digit DIP switch is convenient for users to set I2C address 2.I2C interface, less pin occupation 4.PH2.0 interface and 2.54mm spacing pad

XICOOLEE MCP23017 I/O Expansion Board Module SG-IO-E017, 16 I/O Pins Supports for Raspberry Pi Series, Onboard 3-Digit DIP Switch, I2C Interface

Arduino Sensor Kit - Base — Arduino Online Shop

This module is designed to enable long-range I2C communications which extend the cable length from several meters to about 50 meters. Operating with

Sandbox Electronics Active I2C Long Cable Extender P82B715 Module - Sensors & probes

Sandbox Electronics Active I2C Long Cable Extender P82B715 Module - Sensors & probes – Sensors & Probes

I2C Passive Extender/ Patch Board