EVA (2mm) brick walls - Beyond the Manual - Glowforge Owners Forum

Hello all. I make miniatures and one of the biggest pains in the butt is making brick textures. In the past, I would usually draw lines onto foam board with a dull pencil to simulate the look of brick (then texture the foam with a foil ball). On my last diorama, I decided to try cutting the brick pattern into EVA foam. This worked well for the scale I was doing - 1:24. I think the mortar lines would be too big for smaller scales, due to the size of the kerf, but I haven’t experimented yet.

Pergo Outlast+ Arden Blonde Hickory 12 mm T x 6.1 in. W Waterproof Laminate Wood Flooring (451.4 sqft/pallet) LF000986PLT - The Home Depot

To Cricut or to not Cricuit - ILONA ANDREWS

What to Expect When You Have an EV Charger Installed in Your Home

LEDiL – LED optics – Perfecting light for a luminous future

Can brick be engraved / marked? - Beyond the Manual - Glowforge Owners Forum

Some notes on using canvas - Beyond the Manual - Glowforge Owners Forum

Pergo Outlast+ Arden Blonde Hickory 12 mm T x 6.1 in. W Waterproof Laminate Wood Flooring (451.4 sqft/pallet) LF000986PLT - The Home Depot

Oxford Motorcycle Accessories 2023/24 by Oxford Products - Issuu

Jigging Master Fishing Rod Rubber Gimbal Bottom Cap (Type: A), MORE, Fishing, Rods - Airsoft Superstore

Building a modular zoetrope - Made on a Glowforge - Glowforge Owners Forum

Glowforge is a great piece of machinery, however - Lounge - Dangerous Things Forum

Tips for 2 tone engraveable acrylic/plastic? - Beyond the Manual - Glowforge Owners Forum

Glowforge is a great piece of machinery, however - Lounge - Dangerous Things Forum