Circle trouble - beginning and end are offset - LightBurn Hardware Compatibility - LightBurn Software Forum

Hello, I read lots of posts regarding Circles not round and do not meet but couldn’t see the same issue I experience. I am new to laser cutting and just assembled a Sculpfun S30 Pro (10W) with Y axis extension. When engraving / cutting the first test pattern, the cut circles are oval and there are strange lines off the circles (and rectangles too). I run some additional tests just on the cutting after adjusting the Y axis belt, but it made no difference. I then used LaserGRBL to make t

Atamstack A5 Pro+ will not jive with lightburn - LightBurn Hardware Compatibility - LightBurn Software Forum

The start button is not showing up - Ruida controllers - LightBurn Software Forum

Circle trouble - beginning and end are offset - LightBurn Hardware Compatibility - LightBurn Software Forum

Circle trouble - beginning and end are offset - LightBurn Hardware Compatibility - LightBurn Software Forum

Scanning Offset Adjustment help - LightBurn Software Questions - LightBurn Software Forum

Unround / Unclosed circles on sculpfun s30 pro with expansion - Sculpfun - LightBurn Software Forum

Scan offset not funtioning even after device removed and reconfigured - Ruida controllers - LightBurn Software Forum

Edges/offsets in circles depending on it's starting point (backlash?) - LightBurn Hardware Compatibility - LightBurn Software Forum

Print keeps stopping - Sculpfun - LightBurn Software Forum

Circle trouble - beginning and end are offset - LightBurn Hardware Compatibility - LightBurn Software Forum

Zig Zags on Offset Shapes (Bug?) - LightBurn Software Questions - LightBurn Software Forum

New upload 1.2.04, Offset Fill problem - LightBurn Software Questions - LightBurn Software Forum

Lightburn will not connect/recognize Atezr P10 - LightBurn Hardware Compatibility - LightBurn Software Forum

OLMP2 wont frame or move in relation to workspace - LightBurn Hardware Compatibility - LightBurn Software Forum

Trouble aligning camera - LightBurn Hardware Compatibility - LightBurn Software Forum