PCB Exposure using UV light LED box - Do It Easy With ScienceProg

I came across this interesting project. The guy decided to make a UV PCB exposure box made of UV light LEDs. The main reason why he used LED was the power dissipation and compactness. Assuming that one UV tube would take about 6W while one UV LED would take about (20mAx3.2V=64mW). Most of that energy UV tubes dissipate as heat energy. So he took: 54 x UV LEDs of 400nm (6000 – 7000 mcd) – 100 units in costed 12€;18 x 68ohms resistors 1/4W – 0,36 €;1 connector – 0.50€;1 electrolytic condenser of 2200uF – 30v;1 Eurocard Plate 100×160 about 5 € ; A 12V power supply powers the plate of LEDs. LEDs’ radiation angle is 20º, so they took about 8cm heigh box that light could cover the whole PCB area when distances between LEDs are 18mm. Download circuit and PCB from original site. Continue reading

UV Exposure Box Project – Part 2 – A BIT OF MYSTERY

UV LED PCB Exposure Box

UV LED PCB Exposure Box

LED UV exposure box

Arduino-controlled UV LED PCB Exposure Box : 6 Steps - Instructables

DIY UV PCB Exposure Box ()

PCB Exposure using UV light LED box - Do It Easy With ScienceProg

DIY Portable UV Exposure Box (PCB Making Gadget) - Instructables

UV LED PCB Exposure panel